Dell S4810 - Show Crypto Ipsec Policy

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced support for OSPFv3 on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
You can configure an arbitrary value in the IP address for each router. However,
each router ID must be unique.
If this command is used on an OSPFv3 process that is already active (has
neighbors), all the neighbor adjacencies are brought down immediately and new
sessions are initiated with the new router ID.
Related
Commands
clear ipv6 ospf process – resets an OSPFv3 router process.
show crypto ipsec policy
Display the configuration of IPsec authentication and encryption policies.
S4810
Syntax show crypto ipsec policy [name name]
Parameters
name name (OPTIONAL) Displays configuration details about a specified
policy.
Defaults No default behavior or values.
Command
Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced on the S4810 and Z9000.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Open Shortest Path First (OSPFv2 and OSPFv3)
1261