The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
S4810
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the
no ipv6 address autoconfig command.
Default Disabled
Command
Modes
INTERFACE (management interface only)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Updated Usage Information section.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Usage
Infomation
• SAA can configure up to two addresses. If any preferred prefix or valid timers
time out, the corresponding address are deprecated or removed. If an address
is removed due to a time-out, an address from the current unused prefix is used
to create a new address. If there are no remaining prefixes, the software waits
to receive a new prefix from the RA.
• If auto-configuration is enabled, all IPv6 addresses on that management
interface are auto-configured. Manual and auto-configurations are not
supported on a single management interface.
IPv6 Basics
927
To Next Page
Loading...
