Dell S4810 - Show Ip Bgp Paths Extcommunity

Defaults none
Command
Modes
ROUTE MAP (config-route-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information
If the set community rt and soo are in the same route-map entry, the behavior
defines as:
• If the rt option comes before soo, with or without the additive option, soo
overrides the communities rt sets.
• If the rt option comes after soo, without the additive option, rt overrides
the communities
soo sets.
• If the rt with the additive option comes after soo, rt adds the communities
soo sets.
Related
Commands
set extcommunity rt — sets the extended community route origins using the route-
map.
show ip bgp paths extcommunity
To display all BGP paths having extended community attributes, use this feature.
S4810
Syntax
show ip bgp paths extcommunity
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Border Gateway Protocol
493