Dell S4810 - Show Ipv6 Mld_Host

MTU is 1500
ICMP redirects are not sent
DAD is enabled: number of DAD attempts: 1
ND reachable time is 30 seconds
ND advertised reachable time is 30 seconds
ND advertised retransmit interval is 30 seconds
ND router advertisements are sent every 200 seconds
ND router advertisements live for 1800 seconds
show ipv6 mld_host
Display the IPv6 MLD host counters.
S4810
Syntax
show ipv6 mld_host
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
The following describes the show ipv6 mld-host command shown in the
following example.
Field Description
Valid MLD Packets The total number of packets received and sent from the last
time the elapsed time was cleared.
Reports The total number of reports (queries and unsolicited reports
generated from joins or leaves) that have been received or
sent.
Leaves The number of Multicast leaves that have been sent.
MLDv1 queries The number of MLDv1 queries that have been received.
MLDv2 queries The number of MLDv2 queries that have been received.
Malformed
Packets
The number of MLDv1 and MLDv2 packets that do not
match the requirement for a valid MLD packet.
IPv6 Basics
945