Dell S4810 - Interface Managementethernet

Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Example
Dell(conf)#interface loopback 1655
Dell(conf-if-lo-1655)#
Related
Commands
interface — configures a physical interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
interface ManagementEthernet
Configure the Management port on the system (either the Primary or Standby RPM).
S4810
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port Enter the keyword ManagementEthernet, then the slot
number (0 or 1) and port number zero (0).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the S55, S60, and S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
752
Interfaces