Dell S4810 - Max-Age

Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
forward-delay — changes the wait time before STP transitions to the Forwarding
state.
max-age — changes the wait time before STP refreshes protocol configuration
information.
max-age
To maintain configuration information before refreshing that information, set the time interval for the
spanning tree bridge.
S4810
Syntax
max-age seconds
To return to the default values, use the no max-age command.
Parameters
seconds Enter a number of seconds the Dell Networking OS waits
before refreshing configuration information. The range is
from 6 to 40. The default is 20 seconds.
Defaults 20 seconds
Command
Modes
SPANNING TREE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Spanning Tree Protocol (STP)
1633