Dell S4810 - Ipv6 Router Isis

Defaults No processes are configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.5.1.0 Introduced.
Usage
Information
To assign a network entity title to enable IS-IS, use the net command.
Related
Commands
• net — configures an IS-IS network entity title (NET) for the routing process.
• router isis — enables the IS-IS routing protocol.
ipv6 router isis
Enable the IPv6 IS-IS routing protocol and specify an IPv6 IS-IS process.
S4810
Syntax
ipv6 router isis [tag]
To disable IS-IS routing, use the no router isis [tag] command.
Parameters
tag (OPTIONAL) This parameter is a unique name for a routing
process. A null tag is assumed if the tag option is not
specified. The tag name must be unique for all IP router
processes for a given router.
Defaults Not configured.
Command
Modes
ROUTER ISIS
Intermediate System to Intermediate System (IS-IS)
987