Dell S4810 - Redistribute Ospf

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0
Introduced on the S4810.
Version 7.5.1.0 Added support for IPv6 ISIS.
Version 6.3.1.0 Introduced.
Usage
Information
BGP to IS-IS redistribution supports “match” options using route maps. You can set
the metric value, level, and metric-type of redistributed routes by the redistribution
command. You can “set” more advanced options using route maps.
Example
FTOS(conf)#router is
FTOS(conf-router_isis)#redistribute bgp 1 level-1 metric 32
metric-type
external route-map rmap-isis-to-bgp
FTOS(conf-router_bgp)#show running-config isis
!
router isis
redistribute bgp 1 level-1 metric 32 metric-type external
route-map
rmap-isis-to-bgp
redistribute ospf
Redistribute routing information from an OSPF process.
S4810
Syntax
redistribute ospf process-id [level-1| level-1-2 | level-2]
[match {internal | external}] [metric metric-value] [metric-
type {external | internal}] [route-map map-name]
To return to the default values, use the no redistribute ospf process-id
[level-1| level-1-2 | level-2] [match {internal | external}]
[metric metric-value][metric-type {external | internal}]
[route-map map-name] command.
Parameters
process-id Enter a number that corresponds to the OSPF process ID to
be redistributed. The range is from 1 to 65355.
metric metric-
value
(OPTIONAL) The value used for the redistributed route. Use a
metric value that is consistent with the destination protocol.
The range is from 0 to 16777215. The default is 0.
1012
Intermediate System to Intermediate System (IS-IS)