Dell S4810 - Snmp-Server Community

> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i
alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected
to Router2. This
is a port connected to
IF-MIB::ifAlias.134792448 = STRING:
!------command run on Dell Networkingswitch: --------------!
Dell#snmp ifmib ifalias long
!------command run on server connected to switch:
--------------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i
alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected
to Router2. This
is a port connected to Router2. This is a port connected to
Router2. This is a
port connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:
Dell#config
snmp-server community
Configure a new community string access for SNMPv1 v2 and v3.
S4810
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-
access-list-name [ipv6 ipv6-access-list-name | access-list-name
| security-name name] | security-name name [ipv6 ipv6-access-
list-name | access-list-name | security-name name] | access-
list-name [ipv6 ipv6-access-list-name | access-list-name |
security-name name]]]
To remove access to a community, use the no snmp-server community
community-string {ro | rw} [security-name name [access-list-
name | ipv6 access-list-name | access-list-name ipv6 access-
list-name
]] command.
Parameters
community-
name
Enter a text string (up to 20 characters long) to act as a
password for SNMP.
ro Enter the keyword ro to specify read-only permission.
rw Enter the keyword rw to specify read-write permission.
ipv6 access-
list-name
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a
string up to 16 characters long).
security-name
name
(Optional) Enter the keywords security-name then the
security name as defined by the community MIB.
access-list-
name
(Optional) Enter a standard IPv4 access list name (a string up
to 16 characters long).
1558
Simple Network Management Protocol (SNMP) and Syslog