distribute-list in
Filter network prefixes received in updates.
S4810
Syntax
distribute-list prefix-list-name in [interface]
To return to the default values, use the no distribute-list prefix-list-
name in [interface] command.
Parameters
prefix-list-
name
Specify the prefix list to filter prefixes in routing updates.
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a 1- Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Defaults Not configured.
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.5.1.0 Added IPv6 ISIS support.
Version 6.3.1.0 Introduced.
Intermediate System to Intermediate System (IS-IS)
975
To Next Page
Loading...
