Dell S4810 - Hello-Time

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
max-age — changes the wait time before STP refreshes protocol configuration
information.
hello-time — changes the time interval between BPDUs.
hello-time
Set the time interval between generation of the spanning tree bridge protocol data units (BPDUs).
S4810
Syntax
hello-time seconds
To return to the default value, use the no hello-time command.
Parameters
seconds Enter a number as the time interval between transmission of
BPDUs. The range is from 1 to 10. The default is 2 seconds.
Defaults 2 seconds
Command
Modes
SPANNING TREE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
1632
Spanning Tree Protocol (STP)