Dell S4810 - Test Cam-Usage

Example (Non-
Default)
Dell#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos: 0
Ipv4pbr : 0
-- Line card 4 --
Current Settings(in block sizes)
L2Acl : 5
Ipv4Acl : 5
Ipv6Acl : 1
Ipv4Qos : 1
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos: 0
Ipv4pbr : 0
Dell#
test cam-usage
Verify that enough CAM space is available for the IPv6 ACLs you have created.
S4810
Syntax
test cam-usage service-policy input input policy name linecard
{number | all}
Parameters
policy-map
name
Enter the name of the policy-map to verify. Maximum is 32
characters.
number Enter all to get information for all the linecards/stack-units
or enter the linecard/ stack-unit number to get information
for a specific card. The range is : 0-11 for S4810; 0-7 for all
other S-Series
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
508
Content Addressable Memory (CAM)