Dell S4810 - Show Ip Bgp Cluster-List

neighbor maximum-prefix — controls the number of network prefixes received.
show ip bgp cluster-list
View BGP neighbors in a specific cluster.
S4810
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] cluster-list
[cluster-id]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view cluster information of BGP neighbors
corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
cluster-id (OPTIONAL) Enter the cluster id in dotted decimal format.
The range is 1 — 4294967295.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp cluster-list command shown in
the following example.
Field Description
Network Displays the destination network prefix of each BGP route.
454
Border Gateway Protocol