Dell S4810 - Mac Learning-Limit Learn-Limit-Violation

show mac learning-limit — displays MAC learning-limit configuration.
mac learning-limit learn-limit-violation
Configure an action for a MAC address learning-limit violation.
S4810
Syntax
mac learning-limit learn-limit-violation {log | shutdown}
To return to the default, use the no mac learning-limit learn-limit-
violation {log | shutdown} command.
Parameters
log Enter the keyword log to generate a syslog message on a
learning-limit violation.
shutdown Enter the keyword shutdown to shut down the port on a
learning-limit violation.
Defaults none
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
Usage
Information
This command is supported on physical interfaces, static LAGs, and LACP LAGs.
Related
Commands
show mac learning-limit — displays details of the mac learning-limit.
1044
Layer 2