Dell S4810 - Show Dot1 X Interface

Dell#show dot1x cos-mapping int g 2/21 mac-address
00:00:01:00:07:00
802.1p CoS re-map table on Gi 2/21:
----------------------------------
802.1p CoS re-map table for Supplicant: 00:00:01:00:07:00
Dot1 Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
show dot1x interface
Display the 802.1X configuration of an interface.
S4810
Syntax
show dot1x interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/port information.
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
mac-address (Optional) MAC address of a supplicant.
Defaults none
Command
Modes
• EXEC
• EXEC privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
802.1X
201