Dell S4810 - Bgp Regex-Eval-Optz-Disable

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.2.1.0 Introduced.
Usage
Information
This command is a knob to disable BGP next-hop resolution using BGP learned
routes. During the next-hop resolution, only the first route that the next-hop
resolves through is verified for the route’s protocol source and is checked if the
route is learned from BGP or not.
The clear ip bgp command is required for this command to take effect and to
keep the BGP database consistent. Execute the
clear ip bgp command right
after executing this command.
Related
Commands
clear ip bgp — clears the ip bgp.
bgp regex-eval-optz-disable
Disables the Regex Performance engine that optimizes complex regular expression with BGP.
S4810
Syntax
bgp regex-eval-optz-disable
To re-enable optimization engine, use the no bgp regex-eval-optz-disable
command.
Defaults Enabled
Command
Modes
ROUTER BGP (conf-router_bgp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol
399