Dell S4810 - Show Ip Protocol-Queue-Mapping

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies the service-policy based on the type of protocol defined in
the ACL rules.
Create ACL and QoS policies prior to enabling this command.
Example
Dell#show cpu-queue rate cp for 8 queue platform
Service-Queue Rate (PPS)
-------------- -----------
Q0 1300
Q1 300
Q2 300
Q3 300
Q4 2000
Q5 400
Q6 400
Q7 1100
Dell#
show ip protocol-queue-mapping
Display the queue mapping for each configured protocol.
S4810
Syntax
show ip protocol-queue-mapping
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Example
Dell#show ip protocol-queue-mapping
Protocol Src-Port Dst-Port TcpFlag Queue EgPort
Rate(kbps)
---- -------- -------- ------- ----- ------
Control Plane Policing (CoPP)
515