Dell S4810 - Dcb-Map Stack-Unit All Stack-Ports All; Show Qos Dcb-Map

dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
S4810
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no
dcb-map stack-unit all stack-ports all command.
Parameters
dcb-map-
name
Enter the name of the DCB map.
Defaults None
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage
Information
The dcb-map stack-unit all stack-ports all command overwrites any
previous DCB maps applied to stack ports.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
S4810
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the
specified map.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.3(0.0) Introduced on the S4810 and S6000 platforms.
Version 9.3(0.0) Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
576
Data Center Bridging (DCB)