Dell S4810 - Show Ipv6 Cam Stack-Unit

Defaults Enabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Because this command is enabled by default, it does not appear in the running
configuration. When you disable unicast routing, the no ipv6 unicast-routing
command is included in the running configuration. Whenever unicast routing is
disabled or re-enabled, Dell Networking OS generates a syslog message indicating
the action.
Disabling unicast routing on an E-Series chassis causes the following behavior:
• static and protocol learned routes are removed from RTM and from the CAM;
packet forwarding to these routes is terminated
• connected routes and resolved neighbors remain in the CAM and new IPv6
neighbors are still discoverable
• additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no
new adjacencies are formed
• the IPv6 address family configuration (under router bgp) is deleted
• IPv6 Multicast traffic continues to flow unhindered
show ipv6 cam stack-unit
Displays the IPv6 CAM entries for the specified stack-unit.
S4810
Syntax
show ipv6 cam stack-unit unit-number port-set {0-1} [summary |
index | ipv6 address]
938
IPv6 Basics