Dell S4810 - Interface

on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
Related
Commands
show running-config — displays the flow configuration parameters (non-default
values only).
show interfaces — displays the negotiated flow control parameters.
interface
Configure a physical interface on the switch.
S4810
Syntax
interface interface range
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a null interface, enter the keyword null then the
slot/port information. The Null interface number is 0.
• For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then the
slot/port information. The range is from 1 to 4094.
range (Optional) Enter the keyword range to configure an
interface range.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
748
Interfaces