Dell S4810 - Ipv6 Control-Plane Egress-Filter; Ipv6 Access-List

ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
S4810
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.10.0
Introduced on the S4810.
ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
S4810
Syntax
ipv6 access-list access-list-name cpu-qos {permit | deny}
ospfv3
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-
name
Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control
plane traffic only (CoPP).
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition.
920
IPv6 Access Control Lists (IPv6 ACLs)