Dell S4810 - Redistribute

Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
Although the passive interface does not send or receive routing updates, the
network on that interface still includes in RIP updates sent using other interfaces.
Related
Commands
neighbor — enables RIP for a specified network.
network — defines a neighbor.
redistribute
Redistribute information from other routing instances.
S4810
Syntax
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
connected Enter the keyword connected to specify that information
from active routes on interfaces is redistributed.
static Enter the keyword static to specify that information from
static routes is redistributed.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Routing Information Protocol (RIP)
1405