Dell S4810 - Show Ip Bgp Filter-List

Example
Dell#show run extcommunity-list
!
ip extcommunity-list ecl1
permit rt 100:4
permit soo 40:4
Dell#show ip bgp extcommunity-list ecl1
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf
Weight Path
*> 55.0.0.0/24
172.16.0.2 0 200 i
*> 77.0.0.0/24
172.16.0.2 0 200 i
Dell#show ip bgp extcommunity-list ec
% Error: Extended community list does not exist.
Dell#
show ip bgp filter-list
View the routes that match the filter lists.
S4810
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] filter-list as-path-
name
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view route information that matches the filter lists
corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
as-path-name Enter an AS-PATH access list name. The range is 140
characters.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol
465