Dell S4810 - Member

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Instroduces on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the C-Series and S-Series.
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
dei enable – Make packets eligible for dropping based on their DEI value.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
S4810
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults Not configured.
Command
Modes
CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1694
VLAN Stacking