Dell S4810 - Show Running-Config Pim

Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
GigabitEthernet 8/0
(*, 226.1.1.3), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
GigabitEthernet 8/0
(*, 226.1.1.4), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
GigabitEthernet 8/0
show running-config pim
Display the current configuration of PIM-SM snooping.
S4810
Syntax
show running-config pim
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.4.1.0 Introduced on the E-Series ExaScale.
Example
Dell#show running-config pim
!
ip pim snooping enable
1308
PIM-Sparse Mode (PIM-SM)