Dell S4810 - Arp Backoff-Time

Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when
creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid.
You can use the vrf attribute of this command to create a static ARP entry on
either a default or a non-default VRF. You cannot use this parameter to create any
static ARPs corresponding to management VRFs. When a VRF is deleted using the
no ip vrf command, all the static ARP configurations that belong to that VRF
are removed automatically.
Related
Commands
clear arp-cache — clears dynamic ARP entries from the ARP table.
show arp — displays the ARP table.
arp backoff-time
Set the exponential timer for resending unresolved ARPs.
S4810
Syntax
arp backoff-time seconds
Parameters
seconds Enter the number of seconds an ARP entry is black-holed.
The range is from 1 to 3600. The default is 30.
Defaults 30
Command
Mode
CONFIGURATION
840
IPv4 Routing