Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Use caution when you delete route maps because if you do not specify a sequence
number, all route maps with the same map-name are deleted when you use the no
route-map map-name command.
Example
Dell(conf)#route-map dempsey
Dell(config-route-map)#
Related
Commands
show config — displays the current configuration.
set as-path
To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
S4810
Syntax
set as-path prepend as-number [... as-number]
To remove an AS-Path setting, use the no set as-path {prepend as-number
| tag} command.
Parameters
prepend as-
number
Enter the keyword prepend and then enter up to eight AS
numbers to be inserted into the BGP path information. The
range is from 1 to 65535.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
284
Access Control Lists (ACL)
To Next Page
Loading...
