Dell S4810 - Pfc Mode on

Defaults 45556 quantum
Command
Modes
DCB INPUT POLICY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
The minimum link delay must be greater than the round-trip transmission time a
peer must honor a PFC pause frame multiplied by the number of PFC-enabled
ingress ports.
Related
Commands
dcb-input — creates a DCB input policy.
pfc mode on
Enable the PFC configuration on the port so that the priorities are included in DCBX negotiation with peer
PFC devices.
S4810
Syntax
pfc mode on
To disable the PFC configuration, use the no pfc mode on command.
Defaults PFC mode is on.
Command
Modes
DCB INPUT POLICY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Data Center Bridging (DCB)
527