Dell S4810 - 41 Policy-Based Routing (PBR)

41
Policy-based Routing (PBR)
Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR,
create a redirect list and apply it to the interface. After the redirect list is applied to the interface, all traffic
passing through the interface is subject to the rules defined in the redirect list. PBR is supported by the
Dell Networking Operating System (OS).
The commands in this chapter are supported on the S4810 platform.
You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or
virtual local area network [VLAN]). Trace lists and redirect lists do not function correctly when you
configure both in the same configuration.
NOTE: Apply PBR to Layer 3 interfaces only.
description
Add a description to this redirect list.
S4810
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description Enter a description to identify the IP redirect list (80
characters maximum).
Defaults none
Command
Modes
REDIRECT-LIST
Command
History
Version 9.4.0.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the C-Series and S-Series.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
pre-Version
7.7.1.0
Introduced on the E-Series ExaScale.
Policy-based Routing (PBR)
1271