ip pim query-interval
Change the frequency of PIM Router-Query messages.
S4810
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds
command.
Parameters
seconds Enter a number as the number of seconds between router
query messages. The range is from 0 to 65535. The default is
30 seconds.
Defaults 30 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
ip pim register-filter
To prevent a PIM source DR from sending register packets to an RP for the specified multicast source and
group, use this feature.
S4810
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list
command.
Parameters
access-list Enter the name of an extended access list. Maximum 16
characters.
PIM-Sparse Mode (PIM-SM)
1289
To Next Page
Loading...
