NOTE: You can use this attribute on a specific VRF to
remove history routes corresponding to that VRF. You
can also use this attribute to return the suppressed
routes corresponding to a specific VRF to an active state.
ip-address
mask
(OPTIONAL) Enter an IP address in dotted decimal format
and the prefix mask in slash format (/x) to clear dampening
information only that BGP neighbor.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
After you enter this command, the software deletes the history routes and returns
the suppressed routes to the Active state.
The clear ip bgp dampening command does not clear the history paths.
clear ip bgp flap-statistics
Clear BGP flap statistics, which includes number of flaps and the time of the last flap.
S4810
Syntax
clear ip bgp [vrf vrf-name] flap-statistics [ip-address mask |
filter-list as-path-name | regexp regular-expression]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to clear BGP flap statistics corresponding to that
VRF.
404
Border Gateway Protocol
To Next Page
Loading...
