Dell S4810 - Arp Retries; Arp Timeout

arp retries
Set the number of ARP retries in case the system does not receive an ARP reply in response to an ARP
request.
S4810
Syntax
arp retries number
Parameters
number Enter the number of retries. The range is from 1 to 20. The
default is 5.
Defaults 5
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced.
Usage
Information
Retries are 20 seconds apart.
Related
Commands
show arp retries — displays the configured number of ARP retries.
arp timeout
Set the time interval for an ARP entry to remain in the ARP cache.
S4810
Syntax
arp timeout minutes
Parameters
minutes Enter the number of minutes. The range is from 0 to 35790.
The default is 240 minutes.
IPv4 Routing
843