Dell S4810 - Show Interfaces Phy

detail (OPTIONAL) Enter the keyword detail to display detailed
interface dampening data.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced
Example
Dell#show interfaces dampening
Interface Supp Flaps Penalty Half-Life Reuse Suppress Max-Sup
State
Gi 3/2 Up 0 0 20 800 4500 120
Gi 3/10 Up 0 0 5 750 2500 20
Dell#
Related
Commands
dampening — configures dampening on an interface.
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces configured — displays any interface with a non-default
configuration.
show interfaces phy
Display auto-negotiation and link partner information.
S4810
Syntax
show interfaces gigabitethernet slot/port phy
782
Interfaces