Dell S4810 - Show Interface Pfc

port-set
number
Enter the port-set number.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Specify a stack-unit number on the Master switch in a stack.
Example
Dell# show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
show interface pfc
Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
S4810
Syntax
show interface port-type slot/port pfc {summary | detail}
Parameters
port-type slot/
port pfc
Enter the port-type slot and port PFC information.
{summary |
detail}
Enter the keyword summary for a summary list of results or
enter the keyword
detail for a full list of results.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Data Center Bridging (DCB)
531