Dell S4810 - Show Ip Bgp Peer-Group

Usage
Information
The following describes the show ip bgp paths community command shown
in the following example.
Field Description
Address Displays the internal address where the path attribute is
stored.
Hash Displays the hash bucket where the path attribute is stored.
Refcount Displays the number of BGP routes using these
communities.
Community Displays the community attributes in this BGP path.
Example
Dell#show ip bgp paths community
Total 2 communities
Refcount Community
1 NO-ADVERTISE
1 200:1 1000:1 3000:1
show ip bgp peer-group
Allows you to view information on the BGP peers in a peer group.
S4810
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] peer-group [peer-
group-name [detail | summary]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf to view information on
BGP peers in a peer group corresponding to that VRF.
NOTE: You can use this attribute to view information on
BGP peers in a peer group that correspond to either a
default or a non-default VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
peer-group-
name
(OPTIONAL) Enter the name of a peer group to view
information about that peer group only.
detail (OPTIONAL) Enter the keyword detail to view detailed
status information of the peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status
information of the peers in that peer group. The output is the
same as that found in the show ip bgp summary
command.
Command
Modes
• EXEC
• EXEC Privilege
Border Gateway Protocol
479