Dell S4810 - Description; Max-Paths

description
Enter a description of the BGP routing protocol
S4810
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description Enter a description to identify the BGP protocol (80
characters maximum).
Defaults none
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced.
Related
Commands
router bgp — enters ROUTER mode on the switch.
max-paths
Configure the maximum number of parallel routes (multipath support) BGP supports.
S4810
Syntax
max-paths {ebgp | ibgp} number
To return to the default values, enter the no maximum-paths command.
Parameters
ebgp Enter the keyword ebgp to enable multipath support for
External BGP routes.
Border Gateway Protocol
415