Dell S4810 - Bgp Bestpath As-Path Ignore

router bgp 1
bgp four-octet-as-support
bgp asnotation asdot+
Dell(conf)#router bgp 1
Dell(conf-router_bgp)#bgp asnotation asplain
Dell(conf-router_bgp)#ex
Dell(conf)#do show run |grep bgp
router bgp 1
bgp four-octet-as-support
Dell(conf)#
Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
bgp bestpath as-path ignore
Ignore the AS PATH in BGP best path calculations.
S4810
Syntax
bgp bestpath as-path ignore
To return to the default, enter the no bgp bestpath as-path ignore
command.
Defaults Disabled (that is, the software considers the AS_PATH when choosing a route as
best).
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
If you enable this command, use the clear ip bgp * command to recompute
the best path.
Border Gateway Protocol
383