Dell S4810 - Ip Ospf Hello-Interval

ip ospf hello-interval
Specify the time interval between the hello packets sent on the interface.
S4810
Syntax
ip ospf hello-interval seconds
To return to the default value, use the no ip ospf hello-interval command.
Parameters
seconds Enter the number of seconds for the interval. The range is
from 1 to 65535. The default is 10 seconds.
Defaults 10 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The time interval between the hello packets must be the same for routers in a
network.
Related
Commands
ip ospf dead-interval — sets the time interval before a router is declared dead.
ip ospf message-digest-key
Enable OSPF MD5 authentication and send an OSPF message digest key on the interface.
S4810
Syntax
ip ospf message-digest-key keyid md5 key
To delete a key, use the no ip ospf message-digest-key keyid command.
1182
Open Shortest Path First (OSPFv2 and OSPFv3)