Dell S4810 - Proxy-Gateway Static

proxy-gateway static
Configure the VLT static proxy gateway
S4810
Syntax
[no] proxy-gateway static
Command
Modes
VLT DOMAIN
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage
Information
When proxy-gateway static configuration is made, the setting is saved in the Layer
2 application. When you remove the static proxy gateway configuration, each
proxy-gateway static mac configured is deleted and also the notification to delete
the local destination address (DA) configured is sent to the Layer 2 module. When
remote-mac-address mac-address-identifier configuration is made, the MAC
details are saved. When no remote-mac-address mac-address-identifier
configuration is made, the MAC details and the local DA information are deleted.
Example
Dell(conf)#vlt-domain 1
Dell(conf-vlt-domain#proxy-gateway static
remote-mac-address exclude-vlan
Configure the proxy-gateway static entry and exclude a VLAN or a range of VLANs from proxy routing.
S4810
Syntax
remote-mac-address mac—address exclude-vlan vlan-range
Parameters
remote-mac-
address
Specify the remote MAC address for a static proxy gateway.
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
vlan-range
Enter the member VLANs using comma-separated VLAN IDs,
a range of VLAN IDs, a single VLAN ID, or a combination. For
example:
Comma-separated: 3, 4, 6
Range: 5-10
Combination: 3, 4, 5-10, 8
1712
VLT Proxy Gateway