Dell S4810 - Neighbor Description

When you apply a default route to a BGP peer or peer group using the neighbor
default-originate command, changes to the configured default route-map
are applied to the BGP peer or peer group only after a delay of 15 seconds. As a
result, you must wait for a period of 15 seconds before manually resetting BGP
using the
clear ip bgp command.
In case of eBGP, the neighbor default-originate command does not
support
extended-community as a non-transtive route-map attribute.
You cannot set this configuration for a peer that is associated with a peer group.
Similarly, you cannot associate a peer to a peer group if that peer is already
configured with these settings.
In order that settings corresponding to the neighbor default-originate
command take effect, you must execute the clear ip bgp command
immediately after you execute the neighbor default-originate command.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
S4810
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-
name} description command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
422
Border Gateway Protocol