Dell S4810 - Ip Igmp Immediate-Leave

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.6.1.0 Introduced on the E-Series.
ip igmp immediate-leave
Enable IGMP immediate leave.
S4810
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-
leave command.
Parameters
group-list
prefix-list-
name
Enter the keywords group-list then a string up to 16
characters long of the prefix-list-name.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
Internet Group Management Protocol (IGMP)
719