Dell S4810 - Show Ip Rpf

show ip rpf
View reverse path forwarding.
S4810
Syntax
show ip rpf
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage
Information
Network administrators use static mroutes to control the reach-ability of the
multicast sources. If a PIM-registered multicast source is reachable using static
mroute as well as unicast route, the distance of each route is examined and the
route with shorter distance is the one the PIM selects for reach-ability.
NOTE: The default distance of mroutes is zero (0) and is CLI configurable on a
per route basis.
Example
Dell#show ip rpf
RPF information for 10.10.10.9
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
1150
Multicast