Dell S4810 - Show Fefd

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0
Introduced on the S4810.
Legacy E-
Series
command.
Usage
Information
If you enter only the fefd-global syntax, the mode is normal and the default
interval is 15 seconds.
If you disable FEFD globally (no fefd-global), the system does not remove the
FEFD interface configuration.
Related
Commands
• fefd — enables far-end failure detection.
• fefd-global interval — configures an interval between FEFD control packets.
• show fefd — shows the FEFD command output.
show fefd
View FEFD status globally or on a specific interface.
S4810
Syntax
show fefd [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
1074
Layer 2