Dell S4810 - Clear Management Application Pkt-Cntr; Clear Management Application Pkt-Fallback-Cntr; Management Egress-Interface-Selection

clear management application pkt-cntr
Clear management application packet counters for all management application types.
S4810
Syntax
clear management application pkt-cntr
Defaults None.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Introduced on the Z9000, S4810, and S4820T.
clear management application pkt-fallback-cntr
Clear management application packet fallback counters for all management application types.
S4810
Syntax
clear management application pkt—fallback-cntr
Defaults None.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Introduced on the Z9000, S4810, and S4820T.
management egress-interface-selection
To make configured application traffic egress through the management port instead of the front-end (FE)
port, enable and configure a management egress interface.
S4810
Syntax
management egress-interface-selection
Interfaces
805