Dell S4810 - Hardware Commands; Clear Hardware Stack-Unit

Usage
Information
The buffer-profile global command fails if you have already applied a
custom buffer-profile on an interface. Similarly, when you configure buffer-
profile global
, you cannot not apply buffer-profile on any interface.
If the default buffer-profile is active, Dell Networking OS displays an error message
instructing you to remove the default configuration using the no buffer-
profile global
command.
Reload the system for the global buffer-profile to take effect.
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
S4810
Syntax
clear hardware stack-unit id {counters | unit 0–0 counters |
cpu data-plane statistics | cpu i2c statistics | cpu party-bus
statistics | cpu sata-interface statistics | stack-port 0–127}
Parameters
stack-unit id Enter the keywords stack-unit then a number to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data. The
range is 0 to 11 for the S4810.
counters Enter the keyword counters to clear the counters on the
selected stack member.
unit number
counters
Enter the keyword unit along with a port-pipe number,
then the keyword counters to clear the counters on the
selected port-pipe.
The range is 0 to 0 for the S4810.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear
the data plane statistics.
cpu party-bus
statistics
Enter the keywords cpu party-bus statistics to clear
the management statistics.
stack-port Enter the keywords stack-port then the port number of
the stacking port to clear the statistics of the particular
stacking port.
The range is 0 to 63 for the S4810.
Defaults none
600
Debugging and Diagnostics