Dell S4810 - Show Qos Statistics

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Example
Dell#show qos qos-policy-output
Qos-policy-output qosOut
Rate-limit 50 50 peak 50 50
Wred yellow 1
Wred green 1
show qos statistics
View QoS statistics.
S4810
Syntax
show qos statistics {wred-profile [interface]} | [interface]
Parameters
wred-profile
interface
Enter the keywords wred-profile and optionally one of
the following keywords and slot/port or number information:
• For a 40–Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
interface Enter one of the following keywords and slot/port or number
information:
• For a 40–Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
1376
Quality of Service (QoS)