Dell S4810 - Show Ipv6 Prefix-List; Ipv6 MBGP Commands; Show Ipv6 Mbgproutes

show ipv6 prefix-list
Displays the specified IPv6 prefix list.
S4810
Syntax
show ipv6 prefix-list detail {prefix-list name} | summary
Parameters
detail Display a detailed description of the selected IPv6 prefix list.
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list
names.
summary Display a summary of RPF routes.
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.10.0
Introduced on the S4810.
Related
Commands
ipv6 prefix-list — configures an IPv6 prefix-list.
IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables the multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (AS). FTOS MBGP is
implemented as per IETF RFC 1858.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
S4810
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
Border Gateway Protocol
499