Dell S4810 - Bfd Enable (Interface)

Defaults BFD is disabled by default.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.10.0
Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
bfd enable (Interface)
Enable BFD on an interface.
S4810
Syntax
bfd enable
Defaults BFD is enabled on all interfaces when you enable BFD from CONFIGURATION
mode.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.10.0
Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
364
Bidirectional Forwarding Detection (BFD)