Dell S4810 - Debug Ip Ssh

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0
Added support for FIPS mode on the S4810.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The host keys are required for key-exchange by the SSH server. If the keys are not
found when you enable the server (ip ssh server enable), the keys are
automatically generated.
This command requires user interaction and generates a prompt prior to
overwriting any existing host keys.
NOTE: Only a user with superuser permissions should generate host-keys.
Example
Dell#conf
Dell(conf)#crypto key generate rsa1
Enter key size <1024-2048>. Default<1024>: 1024
Host key already exists. Do you want to replace. [y/n] :y
Dell(conf)#
Related
Commands
ip ssh server — enables the SSH server.
show crypto — displays the SSH host public keys.
debug ip ssh
Enables collecting SSH debug information.
S4810
Syntax
debug ip ssh {client | server}
Security
1507