Dell S4810 - Ipv6 Neighbor

interface
interface
To remove all neighbor entries learned on a specific
interface, enter the keyword interface then the interface
type and slot/port or number information of the interface:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• • For a Port Channel interface, enter the keywords port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
S4810
Syntax
ipv6 neighbor {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor {
ipv6-address} {interface interface} command.
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
1152
Neighbor Discovery Protocol (NDP)